ich habe ein Problem bei Incoming Calls über ISDN Karte.
Asterisk Version 10.8.0-rc1 auf Ubuntu 12.04 LTS
Die Karte wird korrekt vom System erkannt und ausgehende Calls funktionieren einwandfrei.
Bei eingehenden Calls wird dies auf der CLI signalisiert:
Code: Alles auswählen
== ISDN1#02: Incoming call '02216xxxxxx' -> '7532xxxx'
Code: Alles auswählen
capi.conf
;
; CAPI config
;
;
; general section
[general]
nationalprefix=0 ; or for example "+49"
internationalprefix=00 ; or for example "+"
;subscriberprefix=+4969 ; prefix including area code (some lines need this)
rxgain=1.0 ;linear receive gain (1.0 = no change)
txgain=1.0 ;linear transmit gain (1.0 = no change)
language=de ;set default language
; interface sections ...
[ISDN1] ;this example interface gets name 'ISDN1' and may be any
;name not starting with 'g' or 'contr'.
;Use one interface section for each ISDN port!
;ntmode=yes ;if the ISDN card operates in NT-mode, set this to 'yes'
isdnmode=msn ;'MSN' (point-to-multipoint) or 'DID' (direct inward dial)
;when using NT-mode, 'DID' should be set in any case
incomingmsn=* ;allow incoming calls to this list of MSNs/DIDs, * = any
;defaultcid=123 ;set a default caller ID to that interface for dial-out,
;this caller ID will be used when the dial option 'd' is set.
;controller=0 ;ISDN4BSD default
;controller=7 ;ISDN4BSD USB default
controller=1 ;CAPI controller number of this interface/port
group=1 ;dialout group
;prefix=0 ;set a prefix to the calling number on incoming calls
softdtmf=on ;enable/disable software DTMF detection, recommended for AVM cards
relaxdtmf=on ;in addition to softdtmf, you can use relaxed DTMF detection
faxdetect=off ;enable faxdetection and redirection to EXTEN 'fax' for incoming and/or
;outgoing calls. (default='off', possible values: 'incoming','outgoing','both')
faxdetecttime=0 ;Only detect faxes during the first 'n' seconds of the call.
;(default '0' meaning for the whole duration of the call)
faxdestination=custom-fax,fax,1 ;Set custom context, exten and priority to jump to on faxdetect.
;Default is "<current-context>,fax,1".
;accountcode= ;PBX accountcode to use in CDRs
;amaflags=default;AMA flags for CDR ('default', 'omit', 'billing', or 'documentation')
context=isdn-in ;context for incoming calls
Code: Alles auswählen
;ISDN in
[isdn-in]
exten => _X.,1,NoOp
exten => _X.,n,Dial(SIP/80,120,tT)
Please help!
Danke und Grüße